Mélange Water-Based Crystal Clear Topcoat (Matte, Satin, Gloss)
Application Instructions:
Sand all surfaces (finished or unfinished) in the direction of the wood grain to desired smoothness.
Remove all dust from sanded surfaces and clean with a tack cloth.
Do not shake or thin.
Do not apply in direct sunlight or in temperatures below 55°F (10°C) or above 90°F (32°C).
Stir thoroughly prior to and during use.
Using a high-quality nylon/polyester bristle brush, dip approximately an inch into the can, gently tapping it against the inside to remove any excess.
Apply a thin, even coat following the direction of the grain making sure to maintain a wet edge.
For maximum durability, 3 coats are required.
Do not puddle, over-brush or overlap finishes.
Sand lightly between coats with fine sandpaper.
Remove all dust prior to applying additional coats.
Dries to touch in 1 hour.
Sand or Recoat: 1 hour.
After the final coat, allow 12 - 24 hours before light use.
Fully cured: 30 days.
Keep from extreme temps. Keep out of reach of children.
Application Instructions:
Sand all surfaces (finished or unfinished) in the direction of the wood grain to desired smoothness.
Remove all dust from sanded surfaces and clean with a tack cloth.
Do not shake or thin.
Do not apply in direct sunlight or in temperatures below 55°F (10°C) or above 90°F (32°C).
Stir thoroughly prior to and during use.
Using a high-quality nylon/polyester bristle brush, dip approximately an inch into the can, gently tapping it against the inside to remove any excess.
Apply a thin, even coat following the direction of the grain making sure to maintain a wet edge.
For maximum durability, 3 coats are required.
Do not puddle, over-brush or overlap finishes.
Sand lightly between coats with fine sandpaper.
Remove all dust prior to applying additional coats.
Dries to touch in 1 hour.
Sand or Recoat: 1 hour.
After the final coat, allow 12 - 24 hours before light use.
Fully cured: 30 days.
Keep from extreme temps. Keep out of reach of children.
Application Instructions:
Sand all surfaces (finished or unfinished) in the direction of the wood grain to desired smoothness.
Remove all dust from sanded surfaces and clean with a tack cloth.
Do not shake or thin.
Do not apply in direct sunlight or in temperatures below 55°F (10°C) or above 90°F (32°C).
Stir thoroughly prior to and during use.
Using a high-quality nylon/polyester bristle brush, dip approximately an inch into the can, gently tapping it against the inside to remove any excess.
Apply a thin, even coat following the direction of the grain making sure to maintain a wet edge.
For maximum durability, 3 coats are required.
Do not puddle, over-brush or overlap finishes.
Sand lightly between coats with fine sandpaper.
Remove all dust prior to applying additional coats.
Dries to touch in 1 hour.
Sand or Recoat: 1 hour.
After the final coat, allow 12 - 24 hours before light use.
Fully cured: 30 days.
Keep from extreme temps. Keep out of reach of children.
